OCL DLC-1.1, Руководство пользователя, Страница: 4 / 10

INPUT OUTPUT
30,03
600
750
825
1150
EXT
1000
Output power (W)
600
750
825
1150
EXT
1000
Output power (W)
600
750
825
1150
EXT
1000
Output power (W)
The OCL DLC-1.1 Smart Lighting & CO2 Controller is an innovative yet simple way to control your
lamps. As the first and only, the OCL Digital Lighting Controller uses the interlink cable to connect
ballasts via the output of the one to the input of the other. Without any problem up to 50 OCL
XXL-SERIE Full Fixtures can be simultaneously controlled by the OCL DLC-1.1.
TIPS & TRICKS:
The temperature sensor should be protected against the radiation heat of the lamp. A simple
piece of paper board is sufficient. It is recommended to have the OCL temperature sensor close
to the (if present) temperature sensor of the climate control system. The humidity sensor (RH)
measures the relative humidity and here too it is recommended to protect the sensor against
radiation heat and place it in the shadow.
The CO2 sensor should be facing the light because of its light cell, switching the sensor on
(day-time) and off (night-time). Since plants produce CO2 during the night, there is still sufficient
CO2 available in the room when the lights are switched on. In order to save gas, it is possible to
put the “START TIME” on 20 minutes (after the lights switch on).
When dark, the plants do not require any CO2 so it is therefore not necessary to add extra CO2 up
and till the moment the lights are switched off. To save gas, it is possible to put the “STOP TIME”
on 20 minutes (before the lights switch off).
With the “AUX SELECT” option one can choose what piece of equipment will be connected. In the
“NIGHT” setting equipment will be switched on when the lights are switched off. It is recommend-
ed to use this setting because it allows the connection of a heater, dehumidifier or extra ventilator.
When growing with CO2, plants will evaporate more and this could require extra dehumidification
of the room.