OCI PRO-Performance Series -26BQN, Инструкция по использованию и уходу

Страница: 11 / 36

11
WARNING: IMPORTANT!
Before lighting . . .
Inspect the gas supply piping or hose prior to turning the gas “ON”. If there is evidence of
Cuts, wear, or abrasion, it must be replaced prior to use. Do not use the grill if the odor of gas is present while the
knobs are in the OFF position. The pressure regulator and hose assembly supplied with the unit must be used.
Never substitute regulators for those supplied with the grill. If a replacement is necessary, contact the factory for
proper replacement. Screw the regulator (Type QCC1) into the tank. Leak check the hose and regulator connec-
tions with a soap and water solution before operating the grill.
To Light Grill:
Turn all knobs to “OFF” then turn on the gas supply. Always keep your face and body as far
away from the grill as possible when lighting. Open the lid, push and turn the control knob to the “HIGH” position
before the “CLICK” and wait until you hear gas then turn to the left and the gas will ignite automatically after
the click.
If the gas does not ignite redo the steps. MAKE SURE you wait until you hear the gas before you CLICK.
Match lighting:
If the burner will not light after several attempts then the burner can be match lit. If you’ve
just attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. Keep your
face as far away from the grill as possible and hold a lit match over the FLASH TUBE located on the right of the main
grills. This tube leads gas up to be lit.
Push and turn the right control knob which is centered on the burner
t
o “HIGH”.
If the burner does not light in 4 seconds turn the knob “OFF”, wait 5 minutes and try again. Make sure you check the
ignition system for blockage or call a certified service agent to service the grill.
WARNING: Keep hands and face away from front of burner! STAND TO THE SIDE WHEN LIGHTING.
ONCE LIT MOVE HAND AWAY QUICKLY.
Cross lighting:
Once the left or right burner is lit, the adjacent burner(s) can be lit by the cross lighting
method. Push and turn the control knob for the desired center burner to “HI”. The gas will be ignited by the adja-
cent burner’s flame and crossfires. If the burner does not light in 4 seconds, turn knob off, wait 5 minutes and try again.
Please note: cross lighting a grill burner next to an infra-red sear burner will not work!
Always cross light from the right burner to the left burner. The sear -burner cannot in any way be lit with
the cross lighting method! Please use the match lighting or normal ignition method for the sear burner if
your unit is equipped with an infra-red sear burner.
Please Note:
Do not leave the hood in the DOWN POSITION for any length of time. Gas will build up and a
potential for explosion will occur when ignited. DO NOT leave the grill unattended with minors. ALWAYS
place the gas in the OFF POSITION when completed and turn off the gas supply to the GRILL
To Light Rotisserie:
Open the lid, push and turn the control knob SLOWLY to the “HI” position and you will
hear a clicking noise. At this time, a spark will be provided at the Rotisserie igniter. Once lit, turn
control knob to desired setting. If the burner does not light within 4 seconds, turn control knob to “OFF”. If the
igniter does not function, the burner can be lit by holding a lit match to the burner ( with the control knob at
“HIGH”).
Do not attempt to
“LIGHT”
the grill if the odor of gas is present. Call for service.
Keep a spray bottle of soapy water near the gas supply valve and check the connections before each use.
Always ensure that the burner is properly resting on the orifice prior to lighting the burner.