LIGHTING INSTRUCTIONS
10
WARNING: IMPORTANT!
Before lighting . . .
Inspect the gas supply piping or hose prior to turning the gas “ON”. If there is evidence of
cuts, wear, or abrasion, it must be replaced prior to use. Do not use the grill if the odor of gas is present while the
knobs are in the OFF position. The pressure regulator and hose assembly supplied with the unit must be used.
Never substitute regulators for those supplied with the grill. If a replacement is necessary, contact the factory for
proper replacement. Screw the regulator ( Type QCC1 ) into the tank. Leak check the hose and regulator connec-
tions with a soap and water solution before operating the grill.
To Light Grill:
Turn all knobs to “OFF” then turn on the gas supply. Always keep your face and body as far
away from the grill as possible when lighting. Open the lid, push and turn the control knob to the “LITE” position
and immediately press the igniter button and hold. You’ll hear a snapping sound. At the same time a spark will be
provided at the grill burner. It may be necessary to hold the igniter button several seconds until the burner is lit.
Match lighting:
If the burner will not light after several attempts then the burner can be match lit. If you’ve
just attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. Keep your
face as far away from the grill as possible and hold a lit match over the hole located on the top left for burner on
the left, or the right hole for the right burner. Push and turn the control knob which is centered on the burner
where the lit match is located, to “LITE”. If the burner does not light in 4 seconds turn the knob “OFF”, wait 5
minutes and try again.
WARNING: Keep hands and face away from front of burner! STAND TO THE SIDE WHEN LIGHTING.
ONCE LIT MOVE HAND AWAY QUICKLY.
Cross lighting:
Once the left or right burner is lit, the adjacent burner(s) can be lit by the cross lighting
method. For Center burners to cross light, light the adjacent far right burner using the standard or match light pro-
cedure. Push and turn the control knob for the desired center burner to “HI”. The gas will be ignited by the adja-
cent burner’s flame. If the burner does not light in 4 seconds, turn knob off, wait 5 minutes and try again.
Please
note: cross lighting a grill burner next to an infra-red sear burner (36 & 48 models only) will not work!
Always cross light from the right burner to the left burner. The sear -burner cannot in any way be lit with
the cross lighting method! Please use the match lighting or normal ignition method for the sear burner if
your unit is equipped with an infra-red sear burner.
Please Note:
Change your 9V battery at least two times per year to assure proper spark ignition. (See Battery
changing instructions later in this manual)
To Light Rotis:
Open the lid, push and turn the control knob to the “LITE” position. Press and hold safety
button. Press and hold igniter button. You’ll hear a snapping sound. At the same time, a spark will be provided at
the rotis igniter. Hold the safety valve button in for about 5 seconds or until the burner remains lit. Once lit, turn
control knob to desired setting. If the burner does not light within 4 seconds, turn control knob to “OFF”. If the
igniter does not function, the burner can be lit by holding a lit match to the burner ( with the control knob at
LITE”).
l
Do not attempt to “LITE” the grill if the odor of gas is present. Call for service.
l
Keep a spray bottle of soapy water near the gas supply valve and check the connections before each use.
l
Always ensure that the burner is properly resting on the orifice prior to lighting the burner.
