Ochsner OLWI 13, Инструкция по эксплуатации и установке

Страница: 4 / 48

BA_OLW I OTE3_SW5x_EN_20160815_V2 4 / 48
1 Notes on the documentation
The following pointers are a guideline for the
whole documentation.
This manual is to be stored in the vicinity of the
heat pump and must be easily accessible.
1.1 Symbols
The precautionary pointers below will be
used in this document.
WARNING
Pointer which, if not heeded, can mean
danger to life and limb, and can also lead
to material damage. These pointers must
be heeded without fail.
ATTENTION
Pointer which, if not heeded, can lead to an
appliance malfunction and to material dam-
age (to system components, building, ...).
These pointers must be heeded without fail.
2 Safety instructions
Read this manual carefully before you begin to com-
mission/adjust the heat pump!
Converting or altering the appliance is
not allowed. Work on the appliance (re-
pairs, alterations) may only be carried
out by the manufacturer or by a special-
ist authorised by the manufacturer.
All circuit breakers in the heating sys-
tem are to be turned off before any
work is carried out on the terminal
strips or electrical
connections (wiring). The heating sys-
tem consists of the control, the auxilia-
ry modules and the components that
are connected to the control (heat gen-
erator, pumps, safety thermostats, etc.)
Contact with the terminal strips, wires
connected to them, or non-connected
wires by persons or by means of elec-
trically conductive
materials is prohibited as the terminals
strips could be live (danger of touching
power supply).
The control, auxiliary modules, terminal
strips and wiring of the
control can also be supplied with line
voltage by external switching (safety
thermostats, etc.), even if the control is
not connected or is receiving no power
The commissioning as well as the ser-
vicing of the appliances may only be car-
ried out by personnel which are authorised
by OCHSNER.
The installation of the appliances and
their electrical wiring may only be car-
ried out by a specialist according to lo-
cal regulations and codes of practice
.
Protective functions for the heat pump can
be activated by the control. However, as
the control is not certified as a safety ap-
pliance, the protection against failure or
damage to the heat pump must be
adapted to the local instructions (for in-
stance, by additional external switching of
the safety appliances used.
In the event of Upgrades/Updates to the
control software, all parametered
heat pump functions are to be controlled
once again.
2.1 CE Labelling
The product you have purchased conforms to the
technical regulations valid at the time of manufacture,
and is CE-conform.