Ochsner AIR 80 C13A, Инструкции по эксплуатации и монтажу

Страница: 17 / 68

BA_AIR_80_C13A_AIR_80_C22A_OTE3_SW5x_EN_V07.docx Page 17 of 68
Electrical connection
The regulations of the responsible en-
ergy utility and the relevant EN-
standards are to be strictly adhered to.
ATTENTION
Before wiring up the unit make sure
that the heating system carries no line
voltage.
DANGER of electrocution
Install all electrical connections accord-
ing to national and local Standards
Connecting work may only be carried
out by a certified specialist according
to this instruction!
The values indicated for fuse protection are given
solely for reference. The correct sizing of the
safety measures is the sole responsibility of the
electrician connecting the heat pump. The choice
of cable size is to be made by the electrician tak-
ing into account the ratings and cable lengths.
4.9.1 Power supply to the heat pump
The stated voltage must be the same as the
house circuit voltage. Observe the specifications
on the rating label!
The approval of the specific utility must be sought
before connecting the appliance
The circuit breaker for the main power supply
circuit 230V and the main circuit (3 v 400VAC) is
to be a circuit breaker that switches off
all poles
in the event of a malfunction. Main and control
supply cables are to be run separately. The con-
trol supply circuit (230VAC) is to be protected by
a C13A circuit breaker and the main circuit by a
C80A circuit breaker. The supply cable must be
protected against overload and short circuiting.
ATTENTION
This appliance contains frequency con-
verters (e.g. EC circulation pumps).
Leakage currents may arise in normal
operation. In the event of faults, these
components may cause DC fault cur-
rents. An incorrectly selected RCD may
trip during normal operation or, in the
event of a fault, may not trip at all or
only trip after a delay.
-
Make sure that the power
supply for this appliance is
separate from the domestic
installation.
-
Install a type B, AC/DC-
sensitive RCD.
Fig. 23: Electrical connection to the heat pump
Should the minimum clearances of
20cm between sensor wiring and
230V/400V not be able to be adhered
to, sheathed wiring is to be used.
OCHNSER provides no guarantee in cases of sys-
tem damage occurring due to incorrectly sized
safety devices!