Ochsner AIR 80 C13A, Инструкции по эксплуатации и монтажу

Страница: 16 / 68

BA_AIR_80_C13A_AIR_80_C22A_OTE3_SW5x_EN_V07.docx Page 16 of 68
Fig. 22: Max. connecting pipework head of 2.5 mm
Valid for AIR 80 C13A and AIR 80 C22A
4.8.6 Refrigerant pipework
The refrigerant pipework must always be located
on the side of the heat pump (left or right). A rear
connection should only take place in exceptional
circumstances as the connection work is clearly
made more difficult.
4.8.7 Seal test
The seal test is carried out and logged by the
OCHSNER customer service engineers during
commissioning.
4.8.8 Insulation
All refrigerant pipework is to be protected by the
installer against condense water by means of a
workmanlike insulating material. The heat insula-
tion must be additionally UV protected in outside
areas.
Insulation laid in the ground must be
made of closed-pore material. The in-
sulation properties of the material will
otherwise be affected.