MOUNTING
1. Find a suitable mounting location and consider your wiring
route, surfaces and position. For utilizing the movement-to-col-
our function the unit should be mounted in or as close as pos-
sible to the rotational centre of the vessel (See full manual for
details). Please consider location to prevent Wi-Fi and Bluetooth
signal issues.
2. Check to ensure there are no obstructions, such as cables or
pipes behind your mounting area.
3. The unit’s mounting holes are located at the four corners of the
lid.
4. The provided mounting screws are designed to be compatible
with various surfaces, such as wood or fibreglass. Before mount-
ing, mark the desired hole positions and drill pilot holes accord-
ingly. Take caution to verify the absence of any obstructions,
such as cables or pipes behind the drilling area.
5. Mount the OceanBridge unit using the screws provided. Ensure
all four mounting holes are secured. Tighten screws by hand
only.
Ocean LED Marine LTD / Tel +44 (0) 1455 637505 / [email protected]
Ocean LED USA LLC / Tel +1 954 523 2250 / [email protected] /
www.oceanled.com
Specifications are subject to change without notice.
CAN BUS (NMEA2000)
Connect an NMEA2000 drop cable (not provided) to the OceanBridge NMEA2000/Power port and the other end of the
cable to the backbone of the NMEA2000 installation.
ELECTRICAL INSTALLATION
Power Connection
Use the OceanBridge Power Cable (p/n: 013202; not included with OceanBridge – p/n: 013201). Connect the end with the
socket to the OceanBridge NMEA2000/Power port and link the other end to the on-board battery. Connect the +VE Red
wire to a +12/24V fused power source. Connect the -VE Black wire to the battery - (Ground) supply.
