Oceanled E6 TH, Руководство по установке и эксплуатации

Страница: 4 / 40

EXPLORE E6 & E7 TH .
INSTALL & OPERATION MANUAL
3
1
Installation Checklist
1.

Decide on light spacing
– OceanLED recommendations available.
Rear of lights must never be exposed to wet environments inside the hull.
2.

Decide on light angles (only applies for E7 installs)
– OceanLED Personalised Service available on
request.
The Explore E6/E7 TH lights can also be mixed with the Explore E6/E7 XFM
– Please refer to
Appendix Section 7.7 for the installation example.
3.

Ensure the correct power kit is selected and installed (AC or DC power kit).
4.

Ensure correct cable gauge is used (refer to relevant cable gauge chart).
5.

Control system chosen (switch control, OceanLED DMX control kit, 3rd party DMX control)
Max 32 lights per DMX chain (as per recommended by the DMX standard).
6.

Preparing the hull (Isolation kit required for conductive hull materials or wooden hulls).
7.

Ensure the lights have been fitted in the correct orientation, and with the correct beam angle.
8.

Find the appropriate dry location for the driver and AC power pack if used.
9.

Correct marine sealant applied evenly around the bezel. Ensure fully watertight seal is created after
sealant cures.
10.

Correct clamping of light fixture onto hull. Never leave vessel unchecked for a few days after install.
Always check routinely for a few days after installation to ensure the install is correct and fully
sealed.
11.

Light(s) correctly bonded and vessel bonding system check carried out (refer to relevant schematic
and test procedures).
12.

Test installation BEFORE entering water. Never connect/ disconnect lights whilst powered ON.
Never leave lights ON out of water for longer than 5 minutes followed by an off period of 1 hour.
13.

Troubleshooting if required - most issues can be resolved by following the guidelines.