DISCOVER
D3
.
INSTALL & OPERATION MANUAL
5
3
Preparing the Hull
The Discover D3 unit requires an additional 60mm / 2.36
” free space from the rear of the light body to allow
for the cable clearance. (See overall dimensions in the Appendix).
Ensure that the part of the light inside the vessel has a diameter of 60mm/ 2.36
” free space around it free from
any insulation material.
OceanLED recommends using a qualified installer / technician when making modifications to your vessel.
Please also consult the manufacturer for more detail on modifications and installation.
OceanLED recommends use of provided screws. If alternative screws are used, do not use counter sunk or
non-flat shoulder screws to secure your lights to the hull (failure to do so will invalidate your warranty).
If lights are assembled in a conductive or wooden hull suitable fastening (marine grade) need to be used. The
fastenings then should be bonded to the vessel cathodic protection system. Please contact OceanLED for
additional details.
For the correct orientation of the light the logo should face upwards and parallel with the water line. See
drilling template
– in the Appendix, Chapter 7.
Depth/Spacing
Ideally mount your lights at similar depth levels to ensure matching colour consistency through the water. Deeper lights
will look duller and possibly differ in colour compared to shallower mounted units.
SPACING / INSTALL DEPTH
E2
Recommended Spacing
0.5-1.2m (2-4
’)
Recommended Installation depth (From the light waterline)
150-200mm (6-8
”)
Maximum Hull Thickness
Maximum hull thickness: 50mm
(2”)
Hole Cut Out
Hole Cut out size - 44mm (1.73
”)
Overall Dimensions
See overall dimension schematic
– in the Appendix, Chapter 7.
