9
4.
To ensure correct dispersion of light underwater, ensure all Amphibian Xtremes are mounted with
the correct orientation with text facing upwards. (see figure 1.2)
TIP:
During/after fitting process, ensure cable is not under any undue stress.
Fig.2.4
5.
We recommend you only use the mounting screws provided. If alternative screws are used, do not
use counter sunk or non flat shoulder screws. Cover the threads with the sealant and screw into the pre-
drilled pilot holes.
WARNING:
Tighten the screws with a hand tool ONLY!
Fig.2.5
6.
Once you are satisfied that the unit is fully embedded onto the hull, you will notice that sealant has
squeezed out from around the perimeter of the light. Using a cloth wipe off excess sealant to leave
a clean seal. If you do not see sealant squeeze out from the body, you have not used enough sealant
or tightened the unit enough to the hull. Carefully examine the installation to make sure the seal you
have installed on the unit is fully water-tight. If in doubt, remove light, re-apply sealant and re-install.
↑
Fig.2.3
