21
5
Connect the 3 core input cable end of the mains power supply to the boat’s fused power supply using
waterproof connectors or waterproof junction box. (Brown is Live, BLUE is Neutral, GREEN/YELLOW is
Earth)
6.
Secure cables to finsh and test light units BEFORE the boat goes into the water.
NOTE:
Do not run
light(s) for longer than 2 minutes to avoid damage
. If you have any issues and need troubleshooting
advice, please contact your local OceanLED representative.
7.
See section 5.6 for finalizing the installation of OceanLED Lights.
5.3
Installation of Colours 24V DC DMX Driver
Additional items required (not supplied)
• Screws to secure the driver
• Junction box / waterproof connectors
• Sufficient cable to connect to power lead.
• Suitable fuse / breaker(s)
• DMX controller (1 per system)
• DMX terminator (1 per system)
Warning
: Always consult a qualified electrician when connecting OceanLED light fixtures.
Warning
: Never use power tools to secure the drivers: Hand tighten only.
Warning
: Red = Positive; Black = Negative (Ground).
Warning
: When connecting light units, please note that all OceanLED lights will operate within a specific
voltage range. Please check the electrical information to ensure cable gauge, fuse recommendations, breaker
size etc.
Driver connections
• The 2 core input is for the power
• The multi pin Deutsch connector is for the light
• 2x DMX connections (DMX in / DMX out)
Warning
:
Mount drivers in a dry location. Drivers should not sit in standing water at any time.
1.
Fix driver into required position, see below diagram for mounting dimensions and clearances. Ensure
chosen driver location is near enough to connect light cable without applying undue stress
Tip
: Incorrect cable gauge will drop voltage along distances. Decreases in voltage will increase current demand
by the driver unit and will lead to blown fuses and tripped breakers. DO NOT compensate for this by adding
higher rated fuses and/or breakers. Fuses are designed to protect the wiring, not the components.
2
Depending on the quantity of lights installed, you will need to pull the correct sized power cable from
the breaker to the driver locations to supply constant power to the units. It is imperative that the correct
sized tinned marine cable is used. (Refer to Cable Gauge Chart in Appendix).
OceanLED INSTALL / ALLURE / 240717 / 7.1
