Oceanic VEO 1.0, Руководство по эксплуатации

Страница: 56 / 68

56
MODULE REMOVAL FROM BOOT
If the module is in a console, bend the rubber console boot back to expose the edge of
the module. If the boot is flexible enough to permit, you may bend it back far enough to
scoop the module out with your finger. Otherwise, it may be necessary to insert a blunt
screwdriver until the tip rests just underneath the module.
DO NOT pry the module from the console! Slowly increase the pressure under the module
by releasing the tension on the rubber boot. The module will slide up the screwdriver and
exit the console.
If the module is in a wrist boot, it will be necessary to peel the lips of the boot downward
off the module while applying pressure from underneath, working it out slowly.
NOTE: When the battery is replaced within 8 seconds, settings and calcula-
tions for repetitive dives are retained in memory for repetitive dives.
BATTERY REPLACEMENT
The battery compartment should only be opened in a dry and clean environment with
extreme care taken to prevent the entrance of moisture or dust.
To prevent formation of moisture in the battery compartment, it is recommended that the
battery be changed in an environment equivalent to the local outdoor temperature and
humidity (e.g., do not change the battery in an air conditioned environment, then take it
outside during a hot sunny day).