Outdoor Sauna Asssembley Manual
Wall Panel Assembly 1
Oceanic Saunas Ltd
4
Type I
Type II
55
21
Panel Type I
Panel Type II
Note orientation
Corner Piece
Fig 4b. Plan View
Panel Type II
Panel Type I
80mm Screws
Fig 4a. Fix Type I and II panels to form a corner
80mm
4mm
4. Fit Corner Wall Panels
i
Lift one Type I and one Type II panel onto the base rails to form a corner.
ii
Note that for Panel A the tongue of the exterior cladding extending beyond
the edge of the framing should be on the left. (Fig. 3b).
iii
Ensure the leftmost piece of external cladding on Panel Type II is removed
as described on page 3.
iv
Arrange the two panels so that the framing meets without any gap.
v
Drill 4mm countersunk pilot holes through the centre of the framing on
Panel Type B through into the framing of Panel Type A as shown in Fig. 3a.
vi
Fix the panels together using 80mm screws.
vii
Replace the end piece of external cladding previously removed using a pin
gun or hammer in with pins.
viii Locate the corner piece of cladding and fit into the end of Panel Type I
