12
Step 11.
Fitting the glass door we recommend this step is carried out after all the internal fittings have been
installed.
Open the hinges and slide onto the support bases, fasten and adjust using the screws of the fitting as
detailed opposite.
(P12)
Right hand screw = to release hinge and door from frame also allows door to move in and out from frame.
Left hand screw = Move door left to right
Middle adjuster = to move door up and down
To release hinge and door from frame also allows door to move in and out from frame.
Step 12. Affix outer trims.
Affix facia corner blocks (item 11). Fix in place allowing the block to overhang the side of the cabin
approx 8mm and flush with the top of the cabin fix using 25mm pins and glue.
Affix facia (Item 10 – 9 x 32). Use two pieces of item 10 to the front of the cabin and two to each
side (where accessible) fix using 25mm pins.
Affix skirting (Item 10 9 x 32). Use one piece all round cabin – beneath door frame use a 9mm
packer beneath door frame as detailed in step 10.
Affix vertical joint overlaps (Item 9 x 32). Fix using 25mm pins. Spacing as detailed in item 10. Note
corner detail shown opposite (i.e. 3 pieces to a front corner, one to rear side corner).
(P13)
