Ocean Optics NeoFox, Инструкция по установке и эксплуатации, Страница: 17 / 68

2: Installation
013-20000-009-02-201510 9
►
Procedure
Note
You must install the NeoFox Viewer operating software prior to connecting the NeoFox hardware
to the computer. The NeoFox Viewer software installs the drivers required for the NeoFox
hardware. See
Software Installation .
1. Unpack the equipment and verify that you have all the necessary components (see Shipment
Components and Additional Recommended Equipment ).
2. Connect power cord from the power supply that came with your NeoFox unit from back of unit to
an AC outlet. Do NOT look directly at the light being emitted with the naked eye.
Caution
Use only the power supply that came with your NeoFox unit. Using a different power supply
could damage your equipment.
Note
On the NeoFox Sport hardware, there is a difference between the power connector on the DPU
module and the power connector on the NeoFox module. The external power connector on the
NeoFox module is the auxiliary power connector. It provides power only to the NeoFox module
itself. It will not charge the battery or provide power to the DPU. Very few users will ever need to
use the NeoFox module’s auxiliary power connector.
3. Connect the NeoFox unit to your computer using the USB cable. See Installing NeoFox
Hardware Drivers .
Note
On the NeoFox Sport hardware, there is a difference between the USB connector on the DPU
module and the USB connector on the NeoFox module. The USB connector on the NeoFox
module is the NeoFox Sport’s primary USB connector. When the USB cable is attached to the
NeoFox module and the stack power on, you can interact with the NeoFox module through the
NeoFox Viewer software. The USB connector on the DPU is the unit’s auxiliary USB connector.
You will not be able to interact with the device in NeoFox Viewer if you have plugged the USB
cable into the DPU module. You will only want to use this USB port if you need to update the
DPU firmware.
4. Connect the temperature probe (if you have one) to the rear panel of the NeoFox unit.
5. Locate the bifurcated fiber that came with the system. This optical fiber assembly has a “Y”
shaped design.
6. Connect one arm (it doesn’t matter which one) of the bifurcated end of the probe fiber to LED
connector and the other arm to the Detector connector on front of unit.