Ocean Matrix OMX-SW6x6, Инструкция по эксплуатации

Страница: 6 / 17

5
Figure 2:
OMX-SW6x6
Rear Panel Features
Table 2:
OMX-SW6x6
Rear Panel Features
No. Feature Function
1.
1-6 AUDIO INPUTS
RCA connectors
Audio inputs used to connect the stereo audio input sources.
2.
1-6 AUDIO OUTPUTS
RCA connectors
Audio outputs used to connect the stereo audio output acceptors.
3.
RS-485
terminal block Used for bi-directional communication with another Matrix Switcher or PC
through RS-485 interface.
4.
Power Connector A 3-prong AC connector allows power to be supplied to the unit. Directly
underneath this connector, a fuse holder houses the appropriate fuse.
5.
Setup
DIP switches Allow proper configuration of the control signals received and transmitted
through the RS-232 (or RS-485) control port, master/slave modifications, line
termination and device ID numbers.
6.
DB-9 female
RS-232
connector
Used for control of the Matrix Switcher from a PC, or remote control device,
through an RS-232 interface and a null-modem adapter (provided with the
machine).
NOTE: Operation of the machine from a remote PC may be done using the
control software (provided with the machine).
7.
VIDEO OUTPUTS BNC
connectors
Video outputs used to connect the video acceptors.
8.
VIDEO INPUTS
BNC
connectors
Video inputs used to connect the video sources.
9.
SYNC Select
switch Selects either an external sync from the external source, or internal sync, which
is normally inputted via the
VIDEO INPUT #1
connector.
10.
EXT. SYNC
BNC
connector
Used for connection of an external video sync input. The external sync input
can be selected by the
SYNC Select
switch.
RACK MOUNTING
The OMX-SW6x6 may be rackmounted in a standard 19” EIA rack assembly and includes rack
“ears” at the ends of the front panel. The OMX-SW6x6 does not require spacing above or below the
unit for ventilation. To rack mount the OMX-SW6x6 , simply place the unit’s rack ears against the
rack rails of the rack, and insert standard screws through each of the four corner holes in the rack ears.
CONNECTING TO VIDEO DEVICES
Video sources and output devices (such as monitors or recorders) may be connected to the OMX-
SW6x6 through the BNC connectors located on the rear (see the example in Figure 7). Bear in mind
that the output signal format will match that of the input signal format. All signal connections that use
more than one cable interconnecting between devices should be of equal length. (Example: cables
between a camera and the machine should be equal in length).