Oce TCS400, Руководство по самообслуживанию

Страница: 7 / 28

Self-support tips (US) 7
What to do if you are not satisfied with the
output quality
Achieve optimal output quality
Introduction
The Océ TCS400 offers 2 methods for checking print quality.
■
Make a quality check print
■
Make a demo print.
On the system information card on the on-line screen of the printer, use the
lower softkey for 'Demo prints' (key 6 on the folded cover) to enter the menu
with the quality check print and the demo print.
Chapter 7 of the user's manual includes a section about how to check the print
quality.
If you are not satisfied with the output quality, use the following procedure:
1
First, make sure that you load and define the correct media type on the printer.
Use the 'Change media type' wizard to load a media roll and to change the
media type defined on the system.
Then, make sure you define the correct media type for your job.
The following problems are never connected to media. Ignore the above steps
if these problems occur and continue with step 3. (see ‘Important points for
sending print jobs’ on page 15)
■
The length and width measurements are different from the original
■
The colored lines are not aligned
■
Missing sections in lines or stepped lines
■
Missing parts of characters
■
Drop-out caused by nozzle problems.
2
Make sure you defined the correct print mode for your job. (see ‘Defining the
correct job settings for optimal output quality’ on page 9).