Oce CS 5070, Руководство пользователя

Страница: 80 / 139

80 Océ CS 5050/5070 User Manual
Cleaning the ink cartridge jet plate
Clean the ink cartridges when used in a low humidity environment or when
heads become clogged and repeated priming doesn’t solve the problem. In
addition, cleaning may restore print quality in ink cartridges worn out from
prolonged use. However, if this fails, replace the cartridge.
▼ ▼ ▼ ▼
To clean the ink cartridge jet plate
1
Press the
Utility/Access Cartridges
to move the carriage away from the service
station.
2
Disconnect the quick-connect fittings, noting the colour of the fitting to which
the cartridge was connected.
3
Remove the ink cartridge from the printer by gently pulling the top of the
cartridge toward you, then lifting it up out of the carriage.
4
Press lightly against the jets with a water-moistened, lint-free, non-paper cloth
(do not use alcohol). Gently blot any excess ink.
Attention:
Blot only: do not wipe. Wiping may damage the jets. (Ink will
appear on the cloth; this is normal.)
5
Reinstall the cartridge in the carriage and reconnect the ink supply line.
Attention:
Never use alcohol to clean the jet area of the cartridge.
6
Press the
Utility/Access Cartridges
buttons to return the carriage to the service
station.
7
Press the
Utility/Prime
buttons to check the cartridges. Repeat two more times,
if necessary. If the cartridges fire correctly, perform the appropriate calibration
procedures (see ‘Calibrating cartridges’ on page 35).
8
If the cartridge continues to misfire, remove the cartridge. Rinse the ink from
the bottom of the cartridge using warm distilled water.
Note:
Removing the cartridge too often can create a large air bubble in the
line, which can lead to pen problems. Refill the lines with ink if necessary.
9
Dry all surfaces of the cartridge, except for the bottom, or jet area and the
circuit plate.
10
Re-install the cartridge and re-prime.
11
Print out and check the prime test pattern.