O'Brien PRO 301, Руководство пользователя

Страница: 23 / 32

23
308–030
MOTOR & CAPACITOR
To reduce the risk of serious bodily injury, al-
ways follow the Pressure Relief Procedure
Warning on page 14 before checking or re-
pairing any part of the spray system.
WARNING
NOTE: Refer to Fig 20 except where noted.
1. Remove the sprayer’s shroud and the lift han-
dle (2).
2. Disconnect the hose (26) from the displace-
ment pump.
3. Remove the screws (51 & 8b). Pull the drive
housing assembly (A) off the motor housing
(B).
4. Remove the screws (8c) and pull the motor
housing (B) off the motor (13).
5. Drive out the pin (61). Remove the gear (60).
6. Remove the pressure control cover (7). Dis-
connect the motor leads. See Fig 21.
7. Unscrew the nut on the conduit (13f). Unscrew
the bushing (91). See Fig 21. Gently pull the
conduit away from the pressure control and
pull the leads out one at a time.
CAUTION
Always pull the motor leads one at a time to
avoid loosening the terminals.
8. Remove the motor mounting screws (38). Lift
the motor off the frame.
9. Install the new motor in
the reverse order.
10. Clean the gear (60) and inspect it for wear or
damage. Replace if necessary. Secure the
gear with the pin (61). Apply molybdenum dis-
ulfide spray lubricant to the gear, allow to dry,
and then apply industrial-grade, heavy-duty,
extreme-pressure, lithium-soap grease.
NOTE: A circuit board (13b) is included with a
new motor. See page 18 for installation.
Capacitor
1. Remove the cover of the capacitor (13a). See
Fig 21. Remove the flag connectors from the
old capacitor. Connect the flag connectors to
the new capacitor and replace the cover.
NOTE: The replacement capacitor includes a
new resistor, installed.
GREEN &
YELLOW
RED
PINK
Fig 21
BLACK
BROWN
MOTOR
LEADS
7
308
13f
13b
91
Fig 20
61
13
60
8b
8a
8d
8c
A
50
51
26
38
84
13a
2
B
39
40