Change the foil/trimmer
Open the shaving head by pushing the cleaning button to the right and remove the foil/
trimmer unit, picture 3. Replace the upper part of the shaving head into the same position.
Change blade block
Open the shaving head by pushing the cleaning button to the right and remove the foil/
trimmer unit, picture 3. Hold the blade block at both ends and lift it from it´s position, picture
4. Put the new blade block into position and put the foil/trimmer unit back.
Cleaning and maintenance - after each use
Clean the appliance after use. Make sure that the ladyshaver is shut off. Remove the shaving
head by pressing the two buttons on the sides of the main unit, picture 2. Clean the unit with
enclosed brush.
Open the shaving head by pushing the cleaning button to the right and remove the foil/
trimmer unit, picture 3. Remove hair from the foil and trimmer with the brush and also clean
the blade block, picture 5. You can also rinse these parts under running water, picture 6.
Remove remaining hair with the brush. Let the parts dry completely before putting them
back.
The housing can be cleaned with a damp cloth and some mild detergent. Regular cleaning
prolong the efficiency and life of the appliance. Foil/trimmer and blade block should be
lubricated with a few drops of sewing machine oil every third month if you use it frequently,
or after each use if you clean it with water.
Important!
Persons with sensitive skin can easily get irritated skin after shaving. You should
•
therefore try the ladyshaver on a small area on your leg or arm before you use the
appliance.
Do not use products that contains alcohol before or immediately after use of the
•
ladyshaver.
The foil is very thin, do therefore avoid to press it hard and do not drop the appliance.
•
If you press the foil too hard towards the skin during use this may cause irritated skin.
•
Only use cold or lukewarm water when cleaning the shaving head - not hot.
•
Do not use the appliance in your face, on sunburned skin or irritated skin.
•
We recommend that you use lotion after shaving.
•
Safety instructions
1. Read the instruction manual carefully before use, and save it for future use.
2. The appliance must not be immersed into water or other liquids. Should it get wet, it
must be wiped off immediately, as liquids contain minerals which may result in rust in
the electronic parts or which may totally destroy the electronic parts.
3. If the appliance gets dirty, the dirt can be wiped off with a slightly humid cloth, and then
wiped with a dry cloth.
4. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the appliance by
a person responsible for their safety.
5. Children should be supervised to ensure that they do not play with the appliance.
Children are not always able to understand potential risks. Teach children a responsible
handling of electrical appliances.
18
5566_AE_0409.indd 18
2009-04-23 14:24:51
