4.2, Pressure Unit Type:
Under the pressure unit switch setting, short press the left selection key or the right
selection key to enter the settings for Bar and Psi. After setting, press SET key to exit.
4.3. Pressure Limit HI:
In the pressure upper limit setting, the upper pressure limit flashes. Short press the left
selection key or right key to select the adjustment pressure upper limit value, set to the
appropriate value and press the SET key to exit;
4.4, Lower Pressure Limit Lo:
In the lower pressure setting, the lower pressure limit flashes. Short press the left
selection key or right selection key to adjust the pressure lower limit value, set to the
appropriate value and press the SET key to exit;
4.5, Temperature Limit C:
In the upper temperature setting, the upper temperature limit flashes. Short press the
left selection key or the right selection key to adjust the temperature upper limit value, set to the
appropriate value and press the SET key to exit;
Note: After entering the setup state, if no operation is performed within 3 minutes, the
system will automatically exit the setup state;
5.0, ID match for pairing sensors:
Note: After entering the setting state, if no operation is performed within 2 minutes, the system
will automatically exit the setting state;
1. ID matching:
Long press the right selection key to enter the ID matching pair 8 flashes, then press the left key
to start pairing: the 1st wheel icon flashes, and within 2 minutes, install an external sensor, the
receiver receives the signal from the sensor, the 1st wheel When the matching is successful, the
2 beeps of "BI-BI" will enter the 2nd wheel matching, and the corresponding wheel icon flashes;
within 2 minutes, the external sensor is installed, the receiver receives the signal from the
sensor, and the 2nd wheel is successfully matched, "BI-BI" 2 beeps enter the match of wheel 3,
the corresponding wheel icon flashes; within 2 minutes, install the external sensor, the receiver
receives the signal from the sensor, the match of wheel 3 is successful, and the 2 beeps of "BI-BI"
enter the 4th wheel Match, the corresponding wheel icon flashes; within 2 minutes, install an
external sensor, the receiver receives the signal from the sensor, the 4th wheel is successfully
matched, "BI-BI" 2 sounds into the 5th wheel to match, the corresponding wheel icon flashes;
Within 2 minutes, install the external sensor, the receiver receives the signal from the sensor, the
5th wheel is successfully matched, "BI-BI" 2 sounds into the 6th wheel matching, the
corresponding wheel icon flashes; within 2 minutes, install the external The sensor, the receiver
receives the signal from the sensor, the 6th wheel is successfully matched, "BI-BI" 2 sounds into
the 7th wheel to match, the corresponding wheel icon flashes; within 2 minutes, the external
