Functions:
1. Low Power Consumption Dash Unit:
1.1. To manually turn off and on the dash unit press and hold the left button for 3 seconds to
turn on and press and hold the left button for 5 seconds to turn off.
1.2. When the vehicle is stationary, the receiver enters sleep mode and wakes up through the
vibration sensor. As soon as the door is open and shut the dash unit LCD screen will light up and
display the relevant data. Once the car is stationary for 10 minutes, the LCD screen turns off and
the receiver goes to sleep.
2. Display Function:
After the dash unit is started, the LCD screen will display the pressure and temperature
values of each wheel that was recorded before the dash unit entered sleep mode. The battery
charge level will be displayed and when the sun is charging the unit you will see a sun icon. When
the vehicle has been driven more than 10 kilometers the dah unit will update with live pressure
and temperature readings from each tyre.
3. Alarm Function:
The receiver has low pressure, high pressure, fast leakage, high temperature, low
battery and signal loss alarms. Pressing any button will stop the sound of the alarm, but the
blinking display will remain.
3.1, After entering the high pressure alarm, the pressure needs to drop 1.5psi below
high pressure value and the unit will exit alarm mode.
3.2. After entering the low pressure alarm, the pressure needs to rise 1.5psi above the
low pressure alarm valve and the unit will exit alarm mode.
3.3. After entering the high temperature alarm, the temperature drops 2 degrees above
the high temperature alarm value to exit the alarm state.
3.4. When the receiver receives the fast-leakage mark this is when a tyre pressure has
increased or decreased too quickly , the corresponding trye symbol is flashing, and at the same
time, the buzzer makes BI... BI sound. Pressing any key will stop the sound and the display will
remain flashing.
3.5 When the tyre sensor battery is low, the screen lights up, the corresponding tyre
symbol flashes, and the buzzer sounds BI... BI noise, press any button, the sound will stop, the
display will blink.
3.6. The dash unit fails to receive the signal from a sensor. After 25 minutes, the
corresponding tyre information disappears, and BI... BI sounds 5 prompts.
4. Function Settings:
The dash unit has 3 spring touch keys, which are left selection key, set, right selection
key
4.1. Press and hold the “SET” key for 3 seconds. After hearing the BI sound, release it
once and enter the setting state. Then short press the SET key to cycle through the pressure units
Bar/Pis→Pressure upper limit HI→Pressure lower limit Lo→Temperature upper limit C and other
functions. After the function is selected, press the left or right selection key to set the function.
