Section 3D: Installation
10. Attach Bottle Filler assembly to the frame using two (2) torx screws.
Remove the Top Cap and two (2) torx screws used for mounting.
11. Plug bottle filler cord into the electrical outlet. The bottle filler will
auto-calibrate and be set up specifically for that installation. Refer to
the program guide on next page for further programming. Access
programing Pushbutton through top of Bottle Filler.
12. Turn ON water supply and check for leaks. Place a container in the
alcove to release any trapped air from the system.
13. If everything works correctly, place the Top Cap back on the Bottle
Filler and the two (2) torx screws to fasten it in place. Otherwise,
calibrate the sensor per the instructions on the next page.
Insert bottle
INSTALLATION COMPLETE
20
Torx screw
Torx screw
