26
Instruction for use
-
Electrical installations near garden ponds and swimming pools
must comply with international and national installation
guidelines.
-
Keep the connecting points dry!
-
Do not carry or pull the Filtoclear by its connecting lead!
Protect the connecting lead from heat, oil and sharp edges.
-
Lay the hoses and connecting lead in such a way that they are
not an obstacle and do not become damaged!
-
Caution! Danger! Never operate the Filtoclear pressure filter
with integrated UVC with a water pressure greater than 0.2 bar
(2mwh)! The height difference between the filter lid and the
pressure-free outlet point can therefore be 2m max. The
maximum delivery pressure of the pump being used must not
exceed 0.5 bar (5mwh).
-
Only operate the Filtoclear with pressure hoses that are
approved for at least 0.2 bar, i.e. the maximum pressure of the
pump.
-
Check and clean the water outlet to the pond on a regular basis.
The outlet should always be clear, as any blockage would
result in the filter being operated at a pressure greater than 0.2
bar. This in turn would lead to the risk of leaking and therefore
of the pond emptying completely.
-
Important: When the Filtoclear is being used in ‘filter’ mode,
the cleaning connection or any drainage hose connected to it
must always be sealed with the sealing cap and inserted flat
seal in order to prevent the pond from emptying. At the same
time the sealing cap acts as a safeguard in case the function
switch is accidentally set to ‘Clean’.
-
Make sure that the function switch is always set to ‘Filter’ when
the pump is in operation. The function switch may only be set
to ‘Clean’ when cleaning the filter sponges with the handle
function.
-
Before starting up the Filtoclear, check that the connected
hoses, the sealing cap and the tension ring with safety latch are
sitting correctly.
-
Never pump any liquids other than water!
-
When frost is expected, you must remove the Filtoclear with
integrated UVC.
-
Install the Filtoclear where it will not be exposed to direct
sunlight.
-
Please observe the local noise protection regulations.
P
max
= 0,2 bar
