Oase Biotec 5, Руководство пользователя

Страница: 21 / 49

23
Installation
The filter should be installed near to the pond and can easily be
concealed behind bush's. It can also be embedded in the ground
if required (this method also gives added support to the filter).
Please observe the following:
— Install on firm, level ground
( Þ Filter Unit should not be tilted)
( Þ Ensure filter cannot be damaged by stones, rocks etc.)
Installation/Putting into Operation
NW 70
LW
38, 32
25, 19
When using a UVC the filter should be installed at least 2 M's
from the pond. Also take this into consideration if not fitting a
U.V.C. as you may wish to fit one in the future.
Putting into Operation
1. To connect the pump in the pond to the inlet of the filter:
- Cut off the smaller hose connections as necessary.
- If required, dip hose in boiling water to facilitate fitting.
- Route hose carefully to ensure it is not kinked or crushed.
- Fit hose clips.
2. Fit return flow pipework. This can feed a waterfall for example
or return directly to the pond. Pipes must always have a
downward gradient of at least 1%. If pipes are not UV
resistant, cover with soil to protect them.
3. Switch on pump and test the system for flow rate.
You require in addition:
1. Hose
3
/
4
'', 1'', 1 1/4'', 1 1/2'' for connecting pump filter.
2. Hose Clips
3. Hose Tail to fit hose to pump (supplied with Aquamax pumps)
4. Return flow pipework to connect to the outlet DN 70.
Bitron
min.
2 m