Oase Biotec 5, Руководство пользователя

Страница: 20 / 49

22
Assembly, Installation
Assembly, Installation
The following instructions tell you how to assemble the various
parts. Refer to the drawing (see contents) for the arrangement
of the parts.
Assembly procedure:
1. Take the stepped hose tail and the appropriate flat gasket
and screw to the inlet nozzle which goes on the inside of the
filter. ATTENTION: Ensure the slit opening of the nozzle
always points downwards.
2. Fit the outlet 70 mm complete with the appropriate gasket
by inserting it from the outside. Then the backnut can be
fitted and only needs to be hand tight.
3. Insert 3 'Foam Holders' into the inner body from below until
they firmly lock into place. Ensuring inner body is placed on
a flat surface, the foams can be pushed onto the foam
holders. Make sure the foams completely cover the holders
and fit tight against the bottom of the inner body. (NOTE:
It is also possible to use only red foams on the Biotec 5)
4. Insert the inner body lip seal into the recess around the three
lowest sides, starting at the top of the barrier wall.
ATTENTION: Do not stretch the seal or cut off any excess.
5. Put inner body into position inside the chamber and always tight
up against the inlet side of the filter. The barrier wall should always
point towards the outlet side. This completed, lock into place.
6. Fit Biobaskets in the centre ridge (only Biotec 10).
7. Put on cover(s), ensuring that the inspection window always
points towards the filter outlet.
8. Insert thermometer and water level indicator into the inspection
window(s) (see drawing)