Oase Aquarius Universal Classic 440i, Руководство по эксплуатации

Страница: 10 / 36

10
- GB -
−
Ensure that the unit is fused for a rated fault current of max. 30 mA by means
of a fault current protection device.
−
Extension cables and power distributors (e.g. outlet strips) must be suitable for
outdoor use.
−
Ensure that the power connection cable cross section is not smaller than that of
the rubber sheath with the identification H05RN-F. Extension cables must meet
DIN VDE 0620.
−
Protect the plug connections from moisture.
−
Only plug the unit into a correctly fitted socket.
Safe operation
−
Never operate the unit if either the electrical cables or the housing are
defective!
−
Do not carry or pull the unit by its electrical cable.
−
Route all cables such that damage is excluded and nobody can trip over them.
−
Never open the unit housing or its attendant components, unless this is
explicitly required in the operating instructions.
−
Only use original spare parts and accessories for the unit.
−
Never carry out technical modifications to the unit.
−
Only have repairs carried out by customer service points authorised by OASE.
−
The power connection cables cannot be replaced. When the cable is damaged,
the unit or the component needs to be disposed of.
−
Only operate the unit if no persons are in the water!
−
Keep the socket and power plug dry.
Important! The unit is equipped with a permanent magnet. The magnetic
field may affect the function of pacemakers.
Start-up
Attention! The pump must never run dry.
Possible consequence:
The pump will be destroyed.
Protective measure: Check the water level at regular intervals. Always
place the unit below water level.
How to operate the unit:
Install the pump ensuring that it is completely submerged. Allow the air in the
pump to fully escape. Ensure that the maximum permissible immersion depth of 1
m is not exceeded.
The required delivery volume can be set at the control lever:
To set the maximum delivery volume, slide the control lever fully to the left, in the
„+“ direction.
To reduce the delivery volume, slide the control lever to the right, in the „–“ directi-
on.