OARTEC Rowing Simulator, Руководство по эксплуатации

Страница: 11 / 27

CHANGING THE OAR PIVOT SPAN POSITION
There are 2 oar pivot span positions on the outrigger which provide the correct span for rowing or
sculling – the inside hole for sculling and the outside hole for sweep rowing.
To change from one span position to the other, lift and remove the oar from the span hole and insert it in
the correct hole for sweep or sculling. Try to avoid placing downward pressure on the oar handle as the
oar is being removed from the pivot hole as this will engage the spring in the oar pivot end of the oar and
make it more difficult to remove the oar.
CHANGING THE OAR HEIGHT
The oar pivot contains a mechanism to adjust the draw height of the oars to the preference of the rower.
The oars can be set to 2 draw heights - HIGH or LOW. To change between HIGH or LOW height settings
pull the oar away from the drive arm and raise the oar handle up 10 degrees to release the pressure on
the height spring. Rotate the button knob on the oar pivot 90 degrees to the desired setting and start
rowing.
In addition to this adjustment, there is a 2omm plastic spacer located on the oar pivot shaft which can be
removed to lower the overall oar height even more if necessary.
To set the oar heights for sculling where there is clearance between the LEFT oar handle and RIGHT oar
handle, remove the 20mm plastic spacer underneath the RIGHT HAND oar pivot only and set the oar
height to HIGH on the LEFT oar and LOW on the RIGHT oar. The 20mm spacer can be stored on the oar
pivot shaft underneath the outrigger casting when not used on the top side of the outrigger.
SWEEP ROWING PIVOT POSITION SCULLING PIVOT POSITION
OPERATION