2
IMPORTANT SAFETY INSTRUCTIONS
PRODUCT
DESCRIPTION
IMPORTANT SAFETY INSTRUCTIONS CONTINUED
The use of accessories, transducers, and cables other than those specified by the manufacturer, may
result in increased emissions or decreased immunity of the Table.
The Table should not be used adjacent to or stacked with other equipment and that if adjacent or
stacked use is necessary, the Table should be observed to verify normal operation in the configuration
in which it will be used.
The Table is designed to be a stand alone table. This table must not be modified or incorpo-
rated into any other equipment.
As with any moving mechanism there are potential pinch points around and underneath
the table top. It is the responsibility of the operator of this equipment to insure that
bystanders are not in the area below or around this equipment during operation.
Proper operation of this equipment is very important for the safety of the operator, patient,
and any other individuals in the area of this equipment. Directions for use of this
equipment are described on pages 7 through 14. The operator should read these sections carefully.
Weight Limit: (patient and accessories) 550 lbs./250 kg. Do not exceed.
Be certain that the table is completely lowered without any tilt being present prior to
discharging an ambulatory patient. The patient may lose balance and fall.
This table is not suitable for use in the presence of flammable anesthetic mixture with
air or oxygen or nitrous oxide.
When lowering the table or using the Trendelenburg/Reverse Trendelenburg function,
make sure there is nothing underneath the table top that can impede motion (like stools,
cabinets, accessory parts, cleaners, etc).
Use this table only for its intended use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
Close supervision is necessary when this furnishing is used by, or near children, invalids,
or disabled persons.
These tables either have 2 or 3 electric motors to move the table. Each of these devices
has a duty cycle of approximately 10%, meaning 2 minutes of operation within a 20 min-
ute period. Exceeding this duty cycle can damage this equipment.
To reduce the risk of burns, fire, electric shock or injury to persons:
1. Unplug this furnishing from the electrical outlet before cleaning.
2. Unplug from outlet before adding or removing parts.
3. Never operate this furnishing if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or dropped into water. Contact
Oakworks Customer Service before use.
4. Keep the cord away from heated surfaces.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen
is being administered.
Risk of electric shock - Connect this furnishing to a properly grounded outlet only. See
Grounding Instructions. page 6.
Electrical Shock Hazard. The power supply/control module is located under the table seat.
No user serviceable parts are inside. Refer servicing to qualified personnel. Unplug wall plug
prior to contact with any cables connected to the power supply.
CAUTION
READ AND
SAVE THESE
INSTRUCTIONS
WARNING
DANGER
Содержание PG Series
Страница 27: ...24 NOTES NOTES...
