Oakworks Medical PG Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 4 / 28

SYMBOL IDENTIFICATION
1
SYMBOL
IDENTIFICATION
IMPORTANT SAFETY INSTRUCTIONS
CAUTION
READ AND
SAVE THESE
INSTRUCTIONS
The PG Series tables are powered positioning examination tables used to support the
patient during medical procedures. The table is intended to be operated by a healthcare
professional in a medical environment. No special training is required but a review of the
following Safety Instructions is important for the safety of the operator and patient. The
healthcare professional should read and understand this entire manual before use with a
patient. There are no known contraindications to the use of this equipment.
Foot section is not designed to support entire patient weight. Do not sit on foot section.
Table is not to be used as a gurney or to transport patient from room to room.
When the footboards are in the down position, it is possible for them to hit the ground
in low height and high tilt conditions. Operate the table with the footboard up if pos-
sible. If not, then check ground clearance to prevent damage to the footboard.
Medical Electrical Equipment needs special precautions regarding EMC and needs to be installed
and put into service according to the EMC information provided in this manual.
Portable and mobile RF communications equipment can affect Medical Electrical Equipment.
SYMBOL IDENTIFICATION
This symbol, when used in this manual and on product labels, represents
a caution warning. Be sure to read and comply with all precautions and
warnings.
This symbol, when used in this manual and on product labels, warns
against an electrical shock hazard. Be sure to observe and comply with all
warnings.
This symbol, when used in this manual or on product labels, indicates a
Protective Earth (Ground) Terminal.
This symbol, when used in this manual or on product labels, indicates that
the product should be protected from moisture. The humidity specifications
for Transport & Storage are listed on page 29.
This symbol is used to indicate that the operator should consult the user
manual.
This symbol, when used in this manual or on product labels, indicates the
date of manufacture of the device.
This symbol, when used in this manual or on product labels, indicates
alternating current (AC).
This symbol, when used in this manual or on product labels, indicates
direct current (DC).
~
----