OAK CD :0, Руководство пользователя

Страница: 18 / 54

I nitial testing
Power up the Archimedes. If the Archimedes does not start up
correctly, turn everything off and recheck all connections. If the
Archimedes still does not start up, refer to the section headed
`troubleshooting'. Note that each card and drive has been thoroughly
tested at the factory, and so any faults at this stage are most likely to be
caused by incorrect installation, a faulty backplane or faulty
Archimedes.
If the Archimedes does start up correctly, switch on the external
winchester (if fitted). You should hear the drive of the internal or
external winchester spin up to speed and make a few `seek' noises as it
initialises itself.
The winchester is supplied already formatted, and the SCSI card
already initialised, and so the system should now be ready for
configuring. DO NOT USE THE SCSIFORM PROGRAM AT THIS
STAGE. All the options you can set using SCSIFORM have already
been set at the factory! Using SCSIFORM before you are familiar with
the system is more likely to undo necessary settings rather than do
anything useful - you have been warned!
There is no need to type
*configure harddiscs 1
-this
command refers to ST506 winchesters running under ADFS. Only use
this command if you also have an ADFS winchester. Also note that the
*configure drive
command refers only to ADFS drives, so this
is best left set to `0' unless you have an ADFS winchester.
Various configuration values must now be set. Obtain a command line
prompt (e.g. by pressing F12 from the desktop) and type:
*configure scsifs 1 [Return]
then hold down [
Ctrl ]
whilst pressing and releasing [
Break ]
This enables SCSIFS - the filing system provided by the Oak SCSI
controller card. Next, type:
*configure scsidrive 4 [Return]
This makes sure that SCSIFS initially logs on to drive 4 when selected.
Page 1 1