- 16 -
QUICK GUIDE FOR MENU OPERATION
Call menu and for example: Select Language
1. Press INPUT SELECT to select TV mode.
2. Press MENU. The TV menu screen will appear.
3. Press ▲ or ▼ to select “Setup”, then press or ENTER.
4. Press ▲ or ▼ to select “Language”, then press or to
select the desired language.…on the following pages the
menu can be called in the same way as here
DISPLAY
Press DISPLAY to display the current information on the screen. When the TV receives a digital signal,
the digital information will appear.
• Channel number • Station name
• Channel label
• Broadcast program name
• Sleep timer
• Signal type
• Program guide
• Audio language
• Resolution
• Picture size
When the TV receives an analog signal, the analog information will appear.
• Channel number
• Channel label
• Sleep timer
• Signal type
• Audio information
• Picture size
(Stereo, SAP or Mono) • Resolution
Press
DISPLAY
again to clear the call display.
NOTE:
• After a few seconds, DISPLAY screen will return to normal TV-operation automatically.
RECALL
This button allows you to go back to the last channel selected by pressing
RECALL
. Press
RECALL
again to return to the last channel you were watching.
MUTE
Press
MUTE
to switch off the sound. The TV’s sound will be silenced and “Mute” will appear on the
screen. The sound can be switched back on by pressing this button again or the VOL + or –.
SLEEP
To set the TV to turn off after a preset amount of time, press
SLEEP
on the remote control. The clock
will count up 10 minutes for each press of the
SLEEP
button (Off, 0h 10m, 0h 20m, ..., 2h 0m). After
the sleep time is programmed, the display will appear briefly every ten minutes to remind you that the
sleep timer is operating. To confirm the sleep timer setting, press
SLEEP
and the remaining time will
be displayed for a few seconds. To cancel the sleep timer, press
SLEEP
repeatedly until the display
turns to Off.
CH
/
Press and release CH
/
. The channel automatically stops at the next channel set into memory.
For proper operation, before selecting channels, they should be set into the memory. See “Memorizing
channels” on pages 19.
To select the video input source
To view a signal from another device connected to your LCD TV, such as a VCR
player, press INPUT SELECT, then press ▲/ ▼ or corresponding Number buttons
(0-5), then press ENTER. You can select TV, Video, Component, HDMI1, HDMI2 or
PC depending on which input jacks you used to connect your devices.
Nyrius_NY-LED1980N_manual.indd 16
6/17/2010 8:14:10 AM
