24
Please ensure you follow the correct procedure in connecting the valve and sensor wires to WaterMe. The controller has provisions
for up to three fl ow sensors (one included), moisture sensor, rain sensor, a master valve and up to ten solenoid valves.
To connect the valve and sensor wires you will need the following:
No.
Name
1
WaterMe Wireless Irrigation Controller
2
Valve Wires
3
Sensor Wires
4
Mains Power Supply (ensure the power source is within 1.5 metres (5 feet) of the controller)
5
Flathead Screw Driver (not supplied)
!
Note
•
Ensure that the zone wires and sensor wires are in the correct inputs. Incorrect placement will result in a non
working system and may result in potential damage to your WaterMe controller. The inputs to the controller do
have short circuit protection but care during installation is required.
i
Information
•
If your irrigation project requires more than 10 zones it is possible to purchase multiple WaterMe devices
and create one user account.
2
Connecting Wires to the Terminals
1.
Insert the wires through the conduit where you have
made the incision.
2.
Locate the wire entry points you will be using. Using
the fl at head screw driver, turn anti-clockwise to fully
open the terminal housing.
3
3.
Insert the wire into the terminal and retighten turning
the screw driver clockwise. Ensure that you do not
overtighten as it may cause damage to the controller.
SECTION 4.1
