WARNING!
If any burner still does not ignite after a few tries, it could indicate a problem with the gas supply. Turn the gas supply off on the appliance as well as on the gas
cylinder(s) and / or the pressure regulator(s). Do not use the appliance until the cause of the problem has been found
(→ TROUBLESHOOTING).
Igniting the main burner(s) with the electronic ignitor(s)
1.
Wait 5 minutes after all connections are made and make sure no gas is leaking (→ Testing for gas leaks).
2.
Open the cover(s) of the appliance and fold up the wind screen. Refer to the illustration pages in the front section of this instruction manual for details. Turn all
control knobs to the off positions ARRÊT/OFF (Fig. 1).
3.
Open the valve of the gas cylinder(s) and / or the pressure regulator(s) (Fig. 2).
4.
Keep your face and body as far away from the appliance as possible while igniting.
5.
Push and turn the control knob of the selected burner to the HI position (Fig. 3). Push and hold the button of the electronic ignitor until the selected burner lights up. The
electronic ignitor sparks all electrodes of the selected burner group at once.
6.
Set the control knob between HI and LO position (Fig. 4), to adjust the heat.
7.
Ignite the other burner(s) using their respective control knob(s), after the first burner has fired up.
WARNING!
Turn all the control knobs to the off positions ARRÊT/OFF, if any burner does not ignite within 5 seconds. Wait for 5 minutes to let the gas dissipate
and try again.
1
1.
3.
4.
2.
8x
4
2
3
2.
1.
3.
Igniting the main burner(s) with a match
1.
Wait 5 minutes after all connections are made and make sure no gas is leaking (→ Testing for gas leaks).
2.
Open the cover(s) of the appliance and fold up the wind screen. Refer to the illustration pages in the front section of this instruction manual for details. Turn all
control knobs to the off positions ARRÊT/OFF (Fig. 1).
3.
Open the valve of the gas cylinder(s) and / or the pressure regulator(s) (Fig. 2).
4.
Keep your face and body as far away from the appliance as possible while igniting.
5.
Insert a long stick match into the match holder (Fig. 3).
6.
Light the match and insert it into the match lighting hole on the left / right side of the firebox (Fig. X). Push and turn the control knob of the selected burner to the HI
position (Fig. 5).
7.
Set the control knob between HI and LO position (Fig. 6), to adjust the heat.
8.
Ignite the other burner(s) using their respective control knob(s), after the first burner has fired up. Push and turn the control knob(s) and set it to the HI position to
ignite it. The first burner will ignite the nearby burner through cross-lighting.
WARNING!
Turn all the control knobs to the off positions ARRÊT/OFF, if any burner does not ignite within 5 seconds. Wait for 5 minutes to let the gas dissipate
and try again.
16