Testing for gas leaks
WARNING! Risk of explosion!
Never check for gas leaks using a match or any other open flame.
Test all connections, fittings and all gas hoses for gas leaks every time prior use of the appliance, or each time the gas cylinder(s) is / are changed. Make sure this procedure is carried out
in a well ventilated area away from flames, sparks or any heat sources. Do not attempt to light the appliance, if you smell gas.
1.
Make sure that all control knobs on the appliance are in the off positions ARRÊT/OFF.
2.
Open the gas valve of the gas cylinder(s) and / or the pressure regulator(s).
3.
Apply leak detector spray or half water / half soap solution with a brush to all the connection points.
4.
Turn the gas supply on the valve of the gas cylinder(s) and or the pressure regulator(s) off immediately, if you spot gas bubbles forming on the interested areas.
Tighten all connections again and repeat the test.
5.
Do not use the appliance but contact your retailer, if gas bubbles keep forming.
Inserting / exchanging batteries
This appliance is equipped with two battery operated electronic ignitors, sparking the electrodes of a group of four burners (left and right) at once.
1.
Remove the cap of each electronic ignitor by turning it counter-clockwise (Fig. 1).
2.
Insert one LR6/AA battery into the tube (Fig. 2). Observe correct polarity (+ and -)!
3.
Screw the cap back on clockwise (Fig. 3).
1
2
3
Burning-off
WARNING!
Use the appliance only after it has been completely errected! Do not use it in collapsed position!
WARNING!
Use the appliance only with the firebox fixed and secured to the substructure! Do not use it without substructure!
WARNING!
Use the appliance only after the wind screen has been properly unfolded and secured! Do not use it with folded wind screen!
Before first use, remove any production residue and clean the appliance:
1.
Operate the appliance at high temperature with the wind shield folded up for about 10 - 15 minutes to burn-off production residues (→
IGNITING THE BURNER(S)).
2.
Turn the appliance off; allow it to cool and clean all parts (→ CLEANING AND CARE) afterwards.
OPERATION
WARNING! Danger of burns!
This appliance generates heat and escaping steam during use! Take proper precautions to prevent risk of burns, fires, or other damages to people and property!
Wear protective oven mittens or gloves. Use proper tools like barbecue tong and prongs to turn over grillables!
COOKING TIPS
1.
Brush the grill grates with cooking or vegetable oil, before using the appliance. Use a brush with a long handle. The juices from the food drip onto the heater during
cooking and vaporise. The steam arising from this process contributes to the taste of the food.
2.
Set the control knob(s) to the desired temperature in order to reach your desired cooking results.
IGNITING THE BURNER(S)
The burner(s) can be ignited with the built-in electronic ignitor(s) or alternatively manually with a match. Follow the procedure for each method as described below.
WARNING! Risk of explosion!
Always ignite the burner(s) within 5 seconds after turning the control knob to a position in between HI and LO. Gas can collect inside the appliance causing an
explosion on ignition.
15