NXP Semiconductors
UM11762
NTS0304EUK-ARD evaluation board
8. Open the GUI application to operate the device from the PC. For details regarding
GUI operation see
Figure 14. NTS0304EUK-ARD daughterboard / i.MX 8M Mini LPDDR4 EVK board operation
6.4 Using NTS0304EUK-ARD with another device
The NTS0304EUK-ARD daughterboard can be operated with other EVK board, which
has an Arduino port. There are two options to connect the board: using other EVK
equipped with an Arduino port, and an EVK without Arduino port. In the first case, a
firmware shall be developed according with NTS0304E specifications, and then simply
attach NTS0304EUK-ARD daughterboard to the EVK, to operate the board. In the
second case, using the pin chart of Arduino connectors (
), make the necessary
electrical connections (for power, I
2
C-bus and control lines), and develop the desired
firmware, assuring that is compliant with IC specifications. Use NTS0304E datasheet to
read details about internal registers of the DUT IC and data exchange between internal
controller and the EVK. Assure for correct electrical connections and avoid data conflicts
on the signal lines, to prevent IC damage.
7 GUI description
A GUI application is available for the three EVK boards from NXP Semiconductors. The
application is common for all three EVKs described in
This section describes the GUI application and how the user can control the
NTS0304EUK-ARD daughterboard from the graphical interface. First, install the GUI
package and software on the PC (Windows 10). For more details, see
.
Once installation is complete, assure that one of the mentioned three EVKs with attached
NTS0304EUK-ARD daughterboard is connected to a PC and powered-on. Open
“NXP_GUI_NTS0304” GUI application. An interface appears as shown in
UM11762
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2022. All rights reserved.
User manual
Rev. 1.0 — 27 May 2022
22 / 29