NXP Semiconductors NTS0304EUK-ARD, Руководство пользователя, Страница: 16 / 29

NXP Semiconductors
UM11762
NTS0304EUK-ARD evaluation board
Ref Des Label Description
TP12 VCC_5V0_MAIN VCC_5V0_MAIN rail
TP13 VCC_LDO OUT1 VCC_LDOOUT1 rail
TP14 VCC_LDO OUT2 VCC_LDOOUT2 rail
TP15 GND Ground
TP16 GND Ground
Table 6. NTS0304EUK-ARD test points
...continued
5 Installing and configuring software tools
NTS0304EUK-ARD evaluation board is designed and built as a daughterboard working
in conjunction with an Arduino port equipped motherboard. The board was built to be fully
compatible with the following NXP Evaluation (EVK) boards:
• IMXRT1050 EVK Board
• LPCXpresso55S69 Development Board
• i.MX 8M Mini LPDDR4 EVK Board
Each of the above mentioned evaluation / development boards benefits by firmware
support which can be downloaded from NXP company site ( www.nxp.com/ ). Before
starting, the EVK motherboard must be programmed with the corresponding firmware
package. Additionally, a GUI application (Windows 10) is available for download from
the NXP site, allowing rapid testing and operation of NTS0304EUK-ARD daughterboard
through the one of above mentioned EVKs. For details regarding installation of the
EVK firmware and GUI host software on PC please download UM11581 - Arduino
Shields GUI and firmware installation available at https://www.nxp.com/docs/en/user-
guide/UM11581.pdf . Once the software is installed, the first step is to select the correct
combination EVK – NTS0304EUK-ARD daughterboard, and then the board can be
controlled from the GUI interface. See Section 6 and Section 7 for more details regarding
the operation of NTS0304EUK-ARD from GUI software.
6 Configuring the hardware
6.1 Using the NTS0304EUK-ARD with an IMXRT1050 EVK board
Figure 9 shows the required hardware for operation of the NTS0304EUK-ARD
daughterboard with IMXRT1050 EVK. The following items are necessary:
•
One IMXRT1050-EVK board
• One NTS0304EUK-ARD daughterboard
• One USB-A / USB Micro-B cable
• A PC with Windows 10 operating system
The IMXRT1050 EVK motherboard can be powered by one of the three methods:
• Connecting an external 5VDC power supply to the barrel power connector (J2) on the
board
•
Connecting an USB cable from the PC to the Micro-B USB connector (J9) on the board
• Connecting an USB cable from the PC to the USB connector (J28) on the board. When
the PC is connected in this fashion, the USB port can simultaneously act as a debug
UM11762 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2022. All rights reserved.
User manual Rev. 1.0 — 27 May 2022
16 / 29