NXP Semiconductors MCIMC7x-SDB, Быстрый старт, Страница: 6 / 12

Quick Start Guide
STEP-BY-STEP INSTRUCTIONS
This section describes how to use the
SABRE board for smart devices and the
components in the box. This section
also describes the PC requirements to
develop applications using the SABRE
board for smart devices.
Item Description
Board
i.MX 7Dual SABRE board
for smart devices
Power Supply
100/240 V input, 5 V/5 A
output W/AC adapter
Cable
USB cable (micro-B to
standard-A)
Documentation
Quick Start Guide (this
document)
SD Card
Bootable Linux operating
system demonstration
image
Table 1: SABRE Board for Smart Devices Based
on i.MX 7Dual Development Kit Contents
DEVELOPMENT KIT CONTENTS
1
Insert
SD Card
Insert the supplied SD card into the SD
card slot (J6).
Note: Pay careful attention to the
microSD connector as it is fragile. Slide
the connector up or down, following the
open and close arrows on the connector
in order to place the microSD card inside
and lock it in place.
2
Verify Boot
Switches
By default, both of the two boot switches
(SW3) are configured to zero position.
With the SD inserted, the board will boot
from the SD card. Without the SD card
inserted, the board will be switched into
serial downloader mode required by
manufacturing tool (MFGTools). If any
other boot source is desired, please
refer to documentation at
www.nxp.com/iMX7DSABRE