e. On the
Tera Term: Serial port setup dialog, configure the serial port of the host computer with the following
settings:
• Baud rate: 115200
• Data: 8 bit
• Parity: none
• Stop: 1 bit
• Flow control: none
f. Click
OK to close the Tera Term: Serial port setup dialog and complete setting up Tera Term.
12. Press the power button available on the chassis front panel to power on the board. The SYSTEM READY LED on
chassis front-side turns on (Green).
13. The board boots up. The U-Boot log appears on the Tera Term console as given below.
U-Boot 2018.03 (Jan 20 2019 - 13:52:05 +0800)
SoC: LS1028AE Rev1.0 (0x870b0010)
Clock Configuration:
CPU0(A72):1300 MHz CPU1(A72):1300 MHz
Bus: 400 MHz DDR: 1600 MT/s
Reset Configuration Word (RCW):
00000000: 34004010 00000030 00000000 00000000
00000010: 00000000 008f0000 0030c000 00000000
00000020: 01a031a0 00002580 00000000 00003296
00000030: 00000000 00000010 00000000 00000000
00000040: 00000000 00000000 00000000 00000000
00000050: 00000000 00000000 00000000 00000000
00000060: 00000000 00000000 200e705a 00000000
00000070: bb580000 00000000
Model: NXP Layerscape 1028a RDB Board
Board: LS1028AE Rev1.0-RDB, Version: C, boot from NOR
FPGA: v6 (RELEASED: RDB_2018_1206_2148)
SERDES1 Reference : Clock1 = 100.00MHz Clock2 = 100.00MHz
I2C: ready
DRAM: Initializing DDR....
Detected UDIMM Fixed DDR on board
3.9 GiB
DDR 3.9 GiB (DDR4, 32-bit, CL=11, ECC on)
PPA Firmware: Version LSDK-18.09
Using SERDES1 Protocol: 47960 (0xbb58)
PCIe0: pcie@3400000 Root Complex: no link
PCIe1: pcie@3500000 Root Complex: no link
MMC: FSL_SDHC: 0, FSL_SDHC: 1
Loading Environment from SPI Flash... SF: Detected mt35xu02g with page size 256 Bytes, erase
size 128 KiB, total 2 GiB
*** Warning - bad CRC, using default environment
Failed (-5)
EEPROM: NXID v1
In: serial
Out: serial
Err: serial
Net: eth0: enetc#0, eth1: enetc#1, eth2: enetc#2, eth3: netc_mdio, eth4: enetc#3
MDIO MUX: no MDIO MUX node
Hit any key to stop autoboot: 0
NXP Semiconductors
Getting started with LS1028ARDB
QorIQ LS1028A Reference Design Board Getting Started Guide, Rev. 0, 2/2019
User's Guide
16 / 18