NXP Semiconductors
LPCXpresso55S36UM
LPCXpresso55S36 Development Board User Manual
board design. A click board has a pair of 1x8 pin headers that connect to the two
receptacles of a mikroBUS socket.
MikroElektronika (MIKROE) is one of the manufactures of click boards. You can find
details of some example click boards for LPCXpresso55S36 mikroBUS socket at
.
2.13 Motor control and Arduino sockets
The LPCXpresso55S36 board has two Arduino sockets, each with four connectors
(2x6, 2x8, 2x10, and 2x8 position receptacles). In each socket, the two 2x8 position
receptacles are placed diagonally opposite to each other. Each socket is pin-compatible
with an Arduino Uno revision 3 (R3) board. Each socket allows communication with one
FlexPWM module of motor control subsystem of the target MCU (LPC5536).
2.13.1 Motor 1 c unused MCU pin socket
The Motor 1 c unused MCU pin socket allows communication with the following
modules/pins of the target MCU:
•
FlexPWM0 module of motor control subsystem
•
Analog-to-digital converter (ADC) modules, ADC0 and ADC1
•
Digital-to-analog converter (DAC) modules, DAC0 and DAC1
•
Some of the unused MCU pins
The socket includes the following four connectors:
•
J13 (2x6 position receptacle)
•
J10 (2x8 position receptacle)
•
J9 (2x10 position receptacle)
•
J12 (2x8 position receptacle)
The figure below shows the pinouts of Motor 1 c unused MCU pin socket
connectors. Odd pins (inner side pins) of the socket are used for motor control. Even pins
(outer side pins) of the socket are either connected to unused MCU pins or used for other
purposes.
LPCXpresso55S36UM
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2022. All rights reserved.
User manual
Rev. 2 — 5 September 2022
30 / 46
