Top cover
Figure 5. Chassis top view
3. Attach a universal serial bus (USB) cable to the AFD4400-RDB CONSOLE PORT micro-USB port on the chassis
front panel and the host computer.
4. Connect the DC power adapter available in your kit to the PWR IN power connector port on the chassis.
5. Plug the power adapter to your wall outlet.
6. Turn on the power switch on the chassis.
7. Check for the completion of the power-on-reset (PRESET) sequence indicated by the LEDs. The LEDs follow the
sequence listed below:
a. The RESET LED on the chassis and the LEDs D14 to D18 on the board display a steady green light.
b. The LED D19 on the RDB flashes red and turns off, indicating that the AFD4400 processor has exited the reset
state and it is now in a ready state.
c. The FAULT LEDs D7, D12, and D13 stays in the off state, indicating that the system is initiated without any
fault.
8. Turn off the power switch.
NOTE
For more information about the DIP switches and the LEDs available on the
AFD4400-RDB, see the Airfast Digital AFD4400-RDB Reference Manual
(document AFD4400-RDBRM).
6 Preparing and starting up board
To prepare and start up your AFD4400-RDB system, follow the steps listed below:
NOTE
Before you start preparing the board, you must follow the steps listed in the Section 5,
"
Initial board start up
".
Preparing and starting up board
AFD4400 Reference Design Board Quick Start, Rev. 0, 07/2015
6
Freescale Semiconductor, Inc.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
