run bootcmd_ram
• Run the alternate FIT image from the onboard NOR flash using the command listed below.
run bootcmd_secondarykernel
The Linux prompt appears at the U-Boot console.
2. At the Linux prompt, login as
root
.
NOTE
The login does not require any password.
For more information, see the AFD4400-RDB BSP User Guide.
9 Configuring ADI transceiver cards
NOTE
This section is applicable only when an ADI transceiver card is installed on either one or
both the FMC connectors of your AFD4400-RDB.
The figure below shows the AFD4400-RDB with a single ADI transceiver card.
Figure 6. AFD4400-RDB with single ADI transceiver card
NOTE
If you have purchased the ADI card(s) seperately, you need to install it on your board
using the instructions available in its kit.
Configuring ADI transceiver cards
AFD4400 Reference Design Board Quick Start, Rev. 0, 07/2015
10
Freescale Semiconductor, Inc.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
