2 | nVent.com
ENGLISH
Before You Begin
Make sure your nVent RAYCHEM Frostex
9800 FlexFit Plug Kit is complete. It should
contain:
1 9800 FlexFit plug
1 Push-on end seal
2 Orange warning labels
1 Installation instruction
Make sure you have sufficient braided
Frostex heating cable for the job. Do not
use earlier versions of Frostex heating
cable that have no braid. Also make sure
you have the following items:
*Frostex 9610 application tape is
recommended.
Two 10-in (25 cm) plastic cable ties
(not included) may be used to secure
ground-fault unit to pipe insulation.
If you have any questions after reading this
guide, call this toll-free nVent number:
(800) 545-6258.
Save this installation instruction and
user guide. It contains important safety
warnings and maintenance information.
Wire cutters
#2 Phillips
screwdriver
1/2 in–1 in
(13 mm–25 mm)
tape*
Contents
Five Important Safety Warnings .................3
General Instructions .................................... 3
Installation Instructions ............................... 1
Cable Length Selection Tables ..................4
Periodic Inspections .................................... 9
Troubleshooting ........................................... 9
Limited Warranty .......................................10
9800 FlexFit plug
Reset button
Test button
Ground
fault unit
Indicator
light
TEST
Gel-filled
end seal
