NuvoH2O DPHB, Руководство по установке

Страница: 10 / 12

nuvowater
.com
877-688-6426
9
nuvoH2O Cartridge Replacement
1 Before replacing your cartridge, we recommend having a towel on hand
and placing a bucket underneath your softener system.
2 HOME/STUDIO CARTRIDGE
- Turn the black cap at the top of the unit to
“By-Pass” using the wrench that came with your system. (The “By-Pass” option
will allow water to continue to flow to the rest of your home while you replace
the cartridge.) Turn until you hear a clicking sound – this will activate the
pressure release valve.
Note: It is normal for water and air from the cartridge chamber to escape from
under the black cap as the pressure is released.
MANOR CARTRIDGE - Turn the black cap to “By-Pass” using the wrench that
came with your system. (The “By-Pass” option will allow water to continue to
flow to the rest of your home while you replace the cartridge.) Press and hold the
pressure relief valve at the top of the head to relieve pressure in the cartridge chamber.
Note: It is normal for water and air from the cartridge chamber to escape from
under the black cap as the pressure is released.
3 Using the wrench that came with your system, turn the blue collar clockwise
(to the left) to loosen the housing from the head of the system.
CAUTION: The housing will be heavy and full of water!
4 Remove the spent cartridge. Turn it upside down into a sink or tub and let it drain
completely. The outside of the cartridge can be rinsed with warm water. Do not
drain the cartridge in a copper or natural stone sink or tub, and do not let the
waste water come in contact with carpet or flooring.
5 Clean the inside of the housing with dish soap, ½ teaspoon bleach, and water.
Rinse thoroughly .
6 Remove the plastic shrink wrap from your new cartridge and insert the cartridge into
the housing. The small, round holes on the side of the cartridge must be at the top.
7 Inspect the O-ring that seals the housing to the head and ensure that it is seated
properly.
8 Place the housing directly under the head so that the collar may be re-tightened.
Tighten the collar by turning counterclockwise (right). Secure with wrench.
9 Turn the black cap at the top of the unit back to the “Softener” position.
PLEASE NOTE: For maximum efficiency, please do not use the system
immediately. Allow the new cartridge to remain in the housing with
minimal water flow for one hour.