NuvoH2O DPHB, Руководство по установке

Страница: 5 / 12

nuvowater
.com
877-688-6426
4
CAUTION!
Please Read All Instructions Before Beginning Installation
1 Softener MUST be installed vertically.
2 Verify that inflow and outflow lines are properly attached to inlet and outlet ports,
as marked on Housing Head.
3 The brass inserts on the inlet and outlet ports provide stronger threading but can
split or break when over-tightened. DO NOT OVERTIGHTEN.
4 The O-ring in the Housing Body MUST be seated properly. See Basic Installation
Steps for your system in this Guide for details.
5 If installed outdoors, System MUST be protected from sunlight or freezing.
Environmental damage due to direct sunlight or freezing is not covered under
warranty.
6 The recommended pressure setting is 65 psi (4.5 bar). Install a pressure
reduction valve before the housing inlet if water pressure may ever exceed the
Maximum PSI Rating: MAXIMUM PSI RATING – 100 (6.8 BAR)
7 Make sure system is appropriately sized for the intended use. Please check
system specifications on Page 3 prior to installing unit.
8 Remove and discard the foam packing ring and plastic shrink wrapping from
around the cartridge and inside Housing before installation.
9 Cartridge MUST be inserted properly inside housing body (large by-pass holes
at top).
10 If installing a filter with the nuvoH2O system, install the filter before the softening
system.
11 The maximum operating water temperature is 100° F; do not connect to a hot
water supply line.
12 The nuvoH2O system cartridge is rated for usage and/or a specified time period.
The cartridge must be replaced as directed to insure correct operation.
13 The nuvoH2O water softener is not a filter or a purifier; do not use with water
that contains microbiological pathogens, is unsafe, or does not meet the
minimum quality standards of municipal water.
14 The nuvoH2O softener is intended for the treatment of hard water with above
normal pH, do not install if inlet water pH is 7.2 or less.