Nuvo NV-LRC1, Руководство по установке

Страница: 28 / 32

MUTE input, however, will always override other volume response values with the “XM” response.
*********************************************************************************
COMMAND:
* ZxxSETSR<CR> ZoneSet STATUS REQUEST where xx is zone # from 1 to 12.
RESPONSE: # ZxxORp,BASSyy,TREByy,GRPq,VRSTu -p = 1 if at least one of the permanent
values have been overridden* by an RS232 command.
-yy = EQ level, dB, 12 to +0 (flat) to
+12 in 2 dB increments if
set by RS232, -8, -6,-4, 0,
+4, +6, +8 if set on keypad.
-q = 0 if SOURCE GROUP is ON
1 if SOURCE GROUP is OFF
-u = 0 if VOLUME RESET is ON
1 if VOLUME RESET is OFF
*override set to 1 FOR THIS ZONE only if one of commands * ZxxBASSyy<CR> , * ZxxTREByy<CR> , or
* ZxxGRPq<CR> are issued (see descriptions below).
Once a parameter has been SET by one of these commands, it will remain UNTIL:
a. power is cycled on the Main Unit either with the front panel power switch or by removing AC power. Upon power-up,
the system will restore keypad permanent
settings (see the User Manual for details on how to perform these settings).
b. an operator manually sets one of these parameters from a keypad. This takes the unit out of OVERRIDE state, but
other RS232-commanded settings will remain until another RS232 command overrides them, or power is cycled.
This response is also issued whenever these parameters are set from a keypad.
*********************************************************************************
COMMAND:
* ZxxON<CR> Turn zone xx ON.
RESPONSE: Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
* ZxxOFF<CR> Turn zone xx OFF.
RESPONSE: Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
* ALLOFF<CR> Turn ALL zones OFF.
RESPONSE: # ALLOFF<CR>
This RESPONSE is also issued when ALL OFF is pressed on any KEYPAD.
*********************************************************************************
COMMAND:
* ALLV+<CR> Ramp ALL zones UP at a 10 dB/second rate in 1 dB steps.
RESPONSE: # ALLV+<CR>
The ramp action will be cancelled when all zones reach MAXIMUM volume, or when an *ALLHLD<CR> Command is received.
Note that to stop the ramp with this command before maximum volume, one reference zone must be periodically polled with a
*ZxxCONSR<CR>
25