5.
Rotating the wheel to set the temperature.
Rotating the wheel up and down to increase or decrease the
setting temperature. Maximum temperature setting is 95°C or
203°F.
6.
Cook your food.
Press the power button and the current
water temperature will stop flashing then begin heating and
circulating the water. Once the water has reached the set tem-
perature, the alarm will beep four times to indicate that you can
now immerse your sealed bag of ingredients ready for cooking.
The alarm will beep again when water temperature becomes 2
degree lower than set temperature. This will keep food warm
until you want to eat.
7.
Turn the appliance off
. Appliance should be switched off
when cooking is done and when it is not in use. Press the power
button for (3) seconds.
8. Press power button to stop operation. Current temperature
will flash. Press the power button for three seconds and the
appliance will switch OFF.
Press the set button again, All timers and work time will stop
flashing. Do not operate for ten seconds. When setting is
finished, press the power button. The timer will start after the
beep. The appliance will start to heat after the beep when 00:00
is reached. Follow the work time set to counter clockwise, the
appliance will beep and stop heating when the final worktime is
reached. Press the power button and set button at the same time
to change the temperature degree by Celsius or Fahrenneit. If
current water temperature is flashing, that means it is on standy
mode.
4. Timer setting will not flash when you press the set button while
the appliance is working. During operation, press set button,
work time will flash, you could set work time and the appliance
will work normally during this setting.
Power and start bu
�
on
set bu
�
on
Knob adjust the temperature