www.NutriChefKitchen.com
Homebrew Mini Keg Beer Dispenser
PKBRTP60 - PKBRTP110
2L 4L 5L 10L Mini Keg with Spear Tap CO2
Regulator System.
UNIT OPERATION INSTRUCTION
1. Mini keg Growler 2L 4L 5L 10L.
2. Cap Spear Body
3. Gas In Connection Tube
4. Pressure Relieving Valve 30PSI.
5. Cross-bar
6. Regulator Base
7. 30 PSI Pressure Gauge
8. CO2 Regulator Knob
9. CO2 Regulator Aluminium Body
10. Black Plastic Tap Handle.
11. Chrome Plated Faucet Body
12. 16g Threaded CO2 Cartridge/Capsule
PART ONE:
SPEAR ACCEMBLY
1. Please clean mini keg,
cap, spear body, faucet
and beer hose with warm
water and mild soap
before use.
2. Fill your mini keg at your
favourite craft brewery,
or with your own
homebrew.
3. Cut beer hose according
to keg height and insert into Spear, make sure
hose can touch bottom of keg without overlong
or over short.
Remark:
If hose is too short, beer would not be
tapped completely. But if hose is too long, it may
crimp inside the keg, also cause incomplete tapping.
4. Fit tube on to spear, and screw spear into mini keg.
5. Check whether the regulator knob is in OFF
position. If not, please follow arrow mark instruc
tion to turn the regulator knob counter clockwise
to the OFF position.
1
3
2
4
5
10
11
12
8
7
9
6
6. Turn in a new 16g CO2 Capsule with thread type
of 3/8-24UNF, turn clockwise firmly into the
regulator base.
NOTE:
DON’T
stop turning if you hear a slight gas
leak swish, finish turning it in all the way it seal
properly.
PART TWO:
TAPPING
1. Connect the regulator with capsule to the spear.
2. Install Faucet into Spear Body, make sure the
connection is proper and tight.
