628035 1
Prepare cabinet
1. Carefully remove all packing material. Place hardware package aside until
the contents are needed.
Determine location
1. The commonly accepted height of bath cabinets is 64” from the finished
floor to the center of the mirror area. However, height may be adjusted to
individual preference.
2. For maximum security, mount cabinet directly to wall studs.
Mount cabinet
NOTE:
For ease of installation, the assistance of one or two additional
persons is recommended.
1. Measure and mark four (4) mounting holes on the wall corresponding to the
pre-drilled hole locations in the mounting bars on the inside back panel of the
cabinet. (FIG 1) Draw horizontal lines connecting the two
top and two bottom marked locations. The lines should be level. Adjust to
level if necessary. Repeat this process with vertical lines connecting the two
left and two right marked hole locations. After insuring the marks are level,
verify the mounting holes in the cabinet back match the marked wall
locations.
2. Drill 9/64“ diameter holes at the marked locations on the wall. If
mounting holes are not located at a stud, the hole diameter, in the
wall, must be increased to accommodate wall anchors. Position
wall anchors as required.
3. Hold cabinet in place and make sure it is level.
4. Attach the cabinet to the wall with the four mounting screws from
the hardware pack.
NOTE: Do not use nails to mount the cabinet.
NOTE:
Irregularities in wall surface may cause distortion of cabinet
body when mounted. Place shims between cabinet and wall
as necessary.
INSTRUCTIONS FOR WALL-MOUNT INSTALLATIONS
MODEL NO.
SIZE FINISH
755272
24” x 24”
White
755280
30” x 26”
White
755288
36” x 28”
White
755296 48” x 28” White
Register your product online at www.NuTone.com
ASHLAND CABINET
FIG 1
Cabinet Back
Inside View
(without doors)
BOTTOM
MOUNTING
HOLES
TOP
MOUNTING
HOLES
(Double hinge shown)
Door Adjustment
1. Check for clearance and alignment between mirror doors. Mirror doors should
be approximately 1/8” apart and parallel. It may be necessary to adjust
individual doors.
2. Loosen the two screws in the top and bottom hinge leaf on the inside of the
door (FIG 2) by a 1/2 turn for door(s) needing to be adjusted.
3. Realign so the doors are “square” and swing without interference.
4. Retighten the screws carefully by the same 1/2 turn. Do not over tighten.
ONE YEAR LIMITED WARRANTY
Broan-NuTone Storage Solutions warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one (1) year
from the date of original purchase.
THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE.
During this one year period, Broan-NuTone Storage Solutions will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.
This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other
than by Broan-NuTone Storage Solutions), faulty installation or installation contrary to recommended installation instructions. Labor to remove and replace products is not covered.
The duration of any implied warranty is limited to the one year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above
limitation may not apply to you.
BROAN-NUTONE STORAGE SOLUTIONS” OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE STORAGE SOLUTIONS’ OPTION, SHALL BE THE PURCHASER’S SOLE AND
EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE STORAGE SOLUTIONS SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES
ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior
warranties.
Date of Installation __________________________________________________________________________________________________________________________________________
Model No and Product Description _____________________________________________________________________________________________________________________________
IF YOU NEED ASSISTANCE OR SERVICE - CONTACT:
Broan-NuTone Storage Solutions, 501 S. Wilhite Street, Cleburne, TX 76031 www.nutone.com (1-800-325-8351)
DESCRIPTION
PART NUMBER
Accessory Bag “T” Hinge Set
(2 double / 1 single top & 1 single bottom)
B2650003
Mounting Screw 8 X 1-3/4” PPH Type A
*
Wall Anchors
*
SERVICE PARTS
* Standard Hardware – may be purchased locally.
HINGE
LEAF
MIRROR
DOORS
HINGE
BRACKET
CABINET TOP (SHOWN)
or BOTTOM
FIG 2
FIG 2
