Nuna Pipa lite, Руководство пользователя

Страница: 17 / 295

EN EN
20 19
PIPA lite Instructions
PIPA lite Instructions
Make sure that both ISOFIX connectors are
securely attached to their ISOFIX anchor
points. There should be two audible clicks and
the colors of the indicators on the both ISOFIX
connectors should be completely green. (40)
Check to make sure the base is securely
installed by pulling on the both ISOFIX
connectors.
5
After placing the base on the vehicle seat,
extend the load leg to floor. When the load
leg indicator shows green means it is installed
correctly, red means it is installed incorrectly.
(41)
The load leg has 12 positions. When the load
leg indicator shows red this means the load leg
is in the wrong position.
Make sure the load leg is secure by pressing
down on the front of the base.
To shorten the load leg, squeeze the load
leg adjustment button and pull the load leg
upwards. (41)
The completely assembled base is shown as (42)
The ISOFIX connectors must be attached and
locked onto the ISOFIX anchor points. (42)-1
The load leg must be installed correctly with
green indicator. (42)-2
Check the installation
Base should not move side to side or
forward more than 1” at belt path.
Attaching Child Restraint to Base
1
After child is properly secured in infant
carrier, press child restraint on base and listen
for a click. Pull on child restraint to verify
installation. (43)
DO NOT allow child restraint to contact the
vehicle interior (side of car or seat in front)
when installed on base.
2
To release the child restraint, squeeze the
carrier release button (44)-1 located on the
base and then pull the child restraint up. (44)-2
3
To remove the base, first push the base toward
the vehicle seat with a light force. (45)
4
As you push the base toward the vehicle seat,
squeeze the secondary (46)-1 and primary
ISOFIX release buttons (46)-2 . For ease of
release, push the secondary button first, then
the primary button.
5
Press the ISOFIX releasing button to fold the
ISOFIX. (47)
Installation with 3-point-belt
1
Open the vehicle belt lock-off and route the
vehicle safety belt through the belt path. (48)
2
Buckle the vehicle belt. Both the shoulder AND
lap belt must be under the blue lock off and
belts must lay flat. (49)